Detail Fluke 789 ProcessMeter™ With 250 Ohm HART Resistor,,, 087882318405
Buana Survey 021.7321129
Fluke 789
ProcessMeter™ with 250 Ohm HART resistor
The Fluke 787 was the first tool to combine a DMM and a loop calibrator to give process technicians double the power in one tool. Now it' s even better, the range is extended with the new Fluke 789 – the ultimate loop calibration multimeter. The Fluke 789 has a 24-Volt loop supply reducing the need for taking a separate power supply when doing offline transmitter testing. And with its built-in, selectable 250-Ohm Hart® resistor, it also eliminates the need to carry a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.
Features of the FlukeV Loop power supply
Very large dual display
Enhanced backlight with 2 brightness settingsOhm drive capability on mA source
HART mode setting with loop power and a built-in 250 ohm resistor
0% and 100 % buttons to toggle between 4 and 20 mA sourcing for a quick span check
Externally accessible fuses for easy replacement
Infrared-port to process data in FlukeView Forms ( V2.1) softwareFluke 789 features that are also included in the FlukePrecision mA True-RMS digital Multimeter% dc voltage accuracy% dc current accuracy
Frequency measurement to 20 kHz
Min/ Max/ Average/ Hold/ Relative modes
Diode Test and Continuity Beeper
Simultaneous mA and % of scale readoutmA DC current source / loop calibrator / simulator
ProcessMeterAC72 Alligator Clips
Four AA 1.5 V alkaline battery ( installed)
TL71 Safety-Designed Test lead Set
Users Manual and Quick Reference GuideManual Step ( 100% , 25% , Coarse, Fine) plus Auto Step and Auto Ramp
Externally accessible battery for easy battery changes
Tampilkan Lebih Banyak